Denver HSA-120, Инструкция по установке и эксплуатации, Страница: 5 / 28

8 9
Mute Mode
Press the Home Mode button " " and the
Arm " " or Disarm " " button immediately
after. Doing so, the control panel does not
ring out when you arm or disarm your
system.
Emergency Mode
Regardless the status of the system, the alarm
is triggered when the SOS button "SOS" is
pressed on the remote control.
At the same time, the control panel sends a
notification by SMS ("RC- 01 SOS", 01 being
the remote control's number) and dials the
pre-stored phone numbers.
Register in the control panel
Enter Connection Mode on the control panel.
Press any button on the remote control.
Specifications
Power supply:
DC 3V (CR2025 button battery x1)
Static current:
10 uA
Operating current:
≤7 mA
Transmission distance
≤ 80 m (in open area)
Radio-frequency:
433MHz (±75KHz)
Housing material:
ABS plastic
Operating conditions:
Temperature: -10°C ~ +55°C
Relative Humidity: ≤80%
(non-condensing)
Dimensions:
57 x 31 x 11 mm
3.2.2 Wireless Motion Detector
Features
The high perfomance wireless motion detector is boasting a digital dual-core fuzzy logic infrared
control chip with intelligent analysis. This technology identifies interferences created by body
motion and reduces the false alarm rate.
With automatic temperature compensation and anti-air turbulence technology, it easily adapts to
environmental changes.
Design
3
1
2
1. LED indicator
2. Detection window
3. Bracket
PCB Layout
Alarm zone
setup
Tamper
switch*
Infrared
sensor**
AA 1.5V LR6
Antenna
LED working
indicator
*Tamper switch
When the alarm system is armed, the tamper
switch will trigger the alarm if the case is
opened.
**Infrared sensor
Detects the infrared rays released by human
body motion. Do not touch the surface. Keep
the surface clean.
LED indications
Blinks continuously: self-testing
Blinks once:
an intruder is detected
Blinks twice: self-testing is complete; entering working mode.
Blinks once every 3 seconds: under-voltage indication: the batteries must be replaced. (You will be
informed by SMS when the batteries are low if the motion detector is registered in the control panel.)
Usage
Open the case and remove the battery activation strip. Self-testing will start for 30 seconds.