DENTSPLY AUSTENAL ELECTROMATIC-4, Руководство по эксплуатации

Страница: 6 / 31

Electromatic - 4
5
2. SPACE REQUIREMENTS
A. Floor: 49” (124 cm) wide by 38” (97 cm) deep from wall.
NOTE:
The machine base measures 38 1/2” (98cm) by 27 l/2” (70 cm).
Additional clearances of 10” (25 cm) behind and 5” (13 cm) on each side are required.
B. Height: Adequate overhead clearance of 6 feet (183 cm) from the floor must be allowed for
sighting the pyrometer.
3. ELECTRICAL SERVICE REQUIRED
220 Volts A.C., 40 Amps., fused, 50/60 Hz., single phase.
NOTE:
For convenience, it is suggested that the
switch be located on the wall behind the unit,
approximately 50” (127 cm) from the floor.
4. WATER SERVICE REQUIRED (20 psi at 1.5 gpm)
3/8” water line with a shut-off valve and a water filter.
NOTE:
If area pressure is low at times, a water pump may be installed in the incoming line to
provide sufficient pressure.
5. WATER DRAIN
A. Install drain facilities behind the unit
B. If drainage runs are longer than five feet (152.4 cm), the inside diameter of the drain must be
increased to 3/8” (9.5mm) to avoid possible backpressure into the unit.
NOTE:
The level of the drain line should not exceed the height of the machine (36” or 91 cm).
INSTALLATION
1. POSITION THE UNIT
Locate according to installation preparation plans
2. WATER CONNECTIONS (Fig 2)
A. Install WATER FILTER ASSEMBLY (N155554 and N155555) and
WATER PRESSURE REGULATOR (N115282) between water valve
and the machine
B. Attach 3/8” N.P.T. hose barb to WATER FILTER and also to
the machine WATER IN.
C. Attach 1/4” I.D. rubber hose between the filter and the machine
and secure with clamps.
D. Attach 3/8” N.P.T. hose barb to the machine (WATER OUT) connection.
E. Attach 1/4” I. D. (6mm) rubber hose to barb and secure with hose clamp.
F. Run the hose directly to drain.
570 College Ave., York, PA 17405-0872
MADE IN U.S.A.
MODEL
AMP.
SER# VOLTS
HZ.
N155700 220
30 50/60
ELECTROMATIC - 4
FIG. 2
Water In
Water Out