Denso BA20-RU, Руководство пользователя, Страница: 18 / 34

Chapter 4 Customizing the Bluetooth
®
Adapter
You can customize the Bluetooth ® adapter by modifying communications, configuration (as slave/master), and other
parameters with the configuration software “BA Setting*”. These parameters retain their settings even when the
power is off.
* Registered users can download the device drivers and the configuration software “BA Setting” from QBdirect, their
customer support section on the Denso Wave website at no extra charge.
For further details on QBdirect or to register, visit the following URL.
http://www.qbdirect.net
Configuring the Bluetooth
®
adapter
Start
Run the configuration software “BA Setting” on the host computer.
↓
Switch to the setup mode
Hold down the SETUP button provided on the bottom of the Bluetooth
®
adapter for at least 0.5 second with a pin or the like to switch to the setup
mode.
Note:
In the SETUP mode, a USB-COM or RS-232C interface is available
regardless of the interface selected in the Bluetooth
®
adapter. Using the
USB-COM interface for the first time requires installing the Active USB-COM
port driver provided by DENSO WAVE. (For driver installation, refer to
Chapter 2.)
Note:
Leaving the Bluetooth
®
adapter for 3 minutes or more after depression of
the SETUP button automatically exits the setup mode.
↓ Interface/power supply LED: Flashes orange.
Select port
Select the port that connects to the Bluetooth ® adapter.
↓ The configuration software reads the Bluetooth
®
adapter's settings and displays them
on the computer screen.
Set parameters
Modify desired parameter settings.
↓
Exit
Establish the modified settings. After that, the Bluetooth
®
adapter
automatically restarts itself regardless of whether the parameter setting ends
normally.
Note: To modify the settings again after establishment, first switch the
Bluetooth
®
adapter to the setup mode and then run the configuration software
again.
Interface/power supply LED: Lights in green.
10