Denon DN-300BR, Руководство пользователя

Страница: 5 / 28

5
Operation
You can play audio from an audio device that sends its signal over a Bluetooth connection (e.g.,
smartphones, tablet computers, etc.). DN-300BR uses Bluetooth CSR 4.0 and has a range of up to
100 feet (33 meters).
Once you “pair” your Bluetooth device with DN-300BR, they are “connected” wirelessly. You can
play audio on your Bluetooth device, and it will be sent out of DN-300BR’s
outputs (balanced and
unbalanced).
Important:
•
Do not connect antennae to both the front panel and rear panel BNC Antenna Terminals . Using
two antennae will negatively affect the performance of the Bluetooth receiver.
•
DN-300BR will not receive audio from a phone call. While using it, we recommend disabling your
cellular connection, if possible.
•
Do not use DN-300BR near a microwave oven, which can interfere with the reception.
•
While DN-300BR is paired with a Bluetooth device, other Bluetooth devices cannot pair to it. You
must unpair (“disconnect”) the current Bluetooth device from DN-300BR to make it available to
others.
To pair your Bluetooth device to DN-300BR:
1. If DN-300BR is off, use the included power cable to connect its AC input to your power source.
Press the power button to power on DN-300BR. The Status Light will flash slowly.
2. Make sure your desired Bluetooth device has its Bluetooth connectivity on and is within range.
DN-300BR will automatically try to pair with a previously paired Bluetooth device within range, if
any. If you are using that Bluetooth device again, you can start playing audio immediately.
If you want to use a different Bluetooth device, continue to Step 3 .
3. Briefly press DN-300BR’s Pair button. The Status Light will start flashing quickly.
4. On your Bluetooth device, enter its Bluetooth settings menu, and select DN-300BR . When DN-
300BR successfully pairs to a Bluetooth device, the Status Light will stop flashing and remain
lit.
Note: Some older Bluetooth devices may require you to enter a PIN. If this is the case, enter
0000 as the PIN.
If no device pairs within 60 seconds, DN-300BR will exit pairing mode and the Status Light will
flash slowly. To re-enter pairing mode, briefly press DN-300BR's Pair button.
5. On your Bluetooth device, start playing audio.
To adjust your volume level, we recommend setting the volume control of each of your devices
in the following order:
i. your Bluetooth device
ii. DN-300BR, using its Level Knob
iii. your mixer, if any (its input channel level[s], then its main output level)
iv. your loudspeakers
Set each volume level as high as possible without creating distortion or any “clipping” of the
sound.
Important: DN-300BR will not receive audio from a phone call. While using it, we recommend
disabling your cellular connection, if possible.
To unpair your Bluetooth device from DN-300BR, do one of the following:
•
Enter your Bluetooth device’s Bluetooth settings menu, and disconnect from DN-300BR .
•
Press and hold DN-300BR’s Pair button for 3 seconds, and then release it. DN-300BR will
unpair from your Bluetooth device, remove it from the memory of the Bluetooth module, and be
available to pair to another device.