60
Resetting the microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed.
Note that when the microprocessor is reset, all the settings are reset to their default values.
X
SOURCE SELECT
1
SOURCE SELECT
0
1
Turn off the power using
X
.
2
Press
X
while simultaneously pressing
SOURCE SELECT
0
and
SOURCE SELECT
1
.
3
Once the display starts flashing at intervals of about 1 second, release the two
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
Specifications
n
Audio section
•
Power amplifier
Rated output:
Front:
75 W + 75 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
110 W + 110 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Center:
75 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
110 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround:
75 W + 75 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
110 W + 110 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Output connectors:
6 – 16 Ω/ohms
•
Analog
Input sensitivity/Input impedance:
200 mV/47 kΩ/kohms
Frequency response:
10 Hz – 100 kHz — +1, –3 dB (DIRECT mode)
S/N:
98 dB (IHF–A weighted, DIRECT mode)
n
Video section
•
Standard video connectors
Input/output level and impedance:
1 Vp-p, 75 Ω/ohms
Frequency response:
5 Hz – 10 MHz — 0, –3 dB
n
Tuner section
[FM]
[AM]
(Note: μV at 75 Ω/ohms, 0 dBf = 1 x 10–15 W)
Receiving Range:
87.50 MHz – 108.00 MHz
522 kHz – 1611 kHz
Usable Sensitivity:
1.2 μV (12.8 dBf)
18 μV
50 dB Quieting Sensitivity:
MONO
2.8 μV (20.2 dBf)
S/N:
MONO
70 dB (IHF–A weighted, DIRECT mode)
STEREO 67 dB (IHF–A weighted, DIRECT mode)
Total harmonic Distortion (at 1 kHz):
MONO
0.7 % (1 kHz)
STEREO 1.0 % (1 kHz)
n
General
Power supply:
AC 230 V, 50/60 Hz
Power consumption:
330 W
Power consumption in standby mode:
0.3 W (HDMI Pass Through: Off)
For purposes of improvement, specifications and design are subject to change without notice.
Basic instr
uctions
A
dv
anced instr
uctions
Inf
or
mation
Inf
or
mation
DVD
