Getting Started
Connections
Playback
Information
Troubleshooting
ENGLISH
Specifications
[Variable range]
0
~
3
~
7
[Variable range]
–3
~
0
~
+3
Operating from the main unit or remote control
unit
Press
NIGHT
.
OFF
LOW
MID
HI
[Selectable items]
OFF
: Turn night mode off.
LOW
: Low setting.
MID
: Middle setting.
HI
: High setting.
Night Mode
Optimized setting for late-night listening.
Set the dynamic range compression of the output audio.
Panorama
Assign front L/R signal also to surround channels, for wider
sound.
If the surround effect seems weak, set “Panorama” to “ON”.
Dimension
Shift sound image center to front or rear, to adjust playback
balance.
Center Width
Assign center channel signal to front left and right channels for
wider sound.
Dolby PL
g
Music
You can adjust the various surround parameters for optimum
surround effect.
NOTE
The parameter settings are valid only when listening in Dolby Pro
Logic
g
Music mode.
[Display]
[Selectable items]
ON
OFF
[Display]
Information
• The items displayed will differ depending upon the current settings,
the presence or absence of an input signal or the type of input
signal, etc.
• For details of the content of the items displayed, refer to the page
containing an explanation of the settings.
Information on the main unit’s various settings (Status) and on input
signals (Audio Input Signal) is shown on the display.
The information displayed changes each time you press
STATUS
.
The information is displayed for several seconds before the display
returns to its original condition.
[Items to be checked]
• Surround Mode
• Input signal
• Input digital terminal
• Night Mode
• Tone Control
• Channel level of each speaker
etc.
STATUS
Button located on both the main unit and the remote
control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
d
f
STATUS
You can also use the following method to select “Night Mode”.
q
Press
[SURROUND PARAMETER]
.
w
Press
[
o
p
]
.
Setup
For details on how to select, set and cancel settings for each menu, see “Menu Operations” (
v
page 15).
