Denon AVR-1905, Руководство по эксплуатации

Страница: 22 / 85

22
ENGLISH
• To increase the bass or treble: Turn the control
clockwise. (The bass or treble sound can be
increased to up to +12 dB in steps of 2 dB.)
• To decrease the bass or treble: Turn the
control counterclockwise. (The bass or treble
sound can be decreased to up to –12 dB in
steps of 2 dB.)
3 2 1
[1] Adjusting the sound quality (tone)
• The tone control function will not work in the direct mode.
After starting playback
1
The tone switches as follows each time the
TONE CONTROL button is pressed.
2
With the name of the volume to
be adjusted selected, turn the
SELECT knob to adjust the level.
SELECT
3
If you do not want the bass and treble to be
adjusted, turn on the tone defeat mode.
TONE
DEFEAT
The signals do not pass through
the bass and treble adjustment
circuits, so it provides higher
quality sound.
TONE
CONTROL
BASS TREBLE
(Main unit)
[2] Listening over headphones
1
Plug the headphones’ plug
into the jack.
Connect the headphones to
the PHONES jack.
The pre-out output (including
the speaker output) is
automatically turned off when headphones
are connected.
1
PHONES
NOTE:
To prevent hearing loss, do not raise the volume level
excessively when using headphones.
1
Use this to turn off the audio
output temporarily.
Press the MUTING button.
Cancelling MUTING mode.
• Press the MUTING button again.
• Muting will also be cancelled when MASTER
VOL is adjusted up or down.
[3] Turning the sound off temporarily (MUTING)
1
(Main unit)
(Main unit)
(Remote
control unit)
1
Simulcast playback
Use this switch to monitor a video
source other than the audio source.
Press the VIDEO SELECT button
repeatedly until the desired source
appears on the display.
Cancelling simulcast playback.
• Select “SOURCE” using the VIDEO SELECT
button.
• Switch the program source to the component
connected to the video input jacks.
1
[4] Combining the currently playing sound with the desired image
[5] Checking the currently playing program source, etc.
1
On screen display
• Each time an operation is
performed, a description of that
operation appears on the
display connected to the unit’s
VIDEO MONITOR OUT jack.
Also, the unit’s operating status can be
checked during playback by pressing the
remote control unit’s ON SCREEN/DISPLAY
button.
Such information as the position of the input
selector and the surround parameter settings
is output in sequence.
BRIGHT MEDIUM
OFF
DIM
2
Using the dimmer function
• Use this to change the
brightness of the display.
The display brightness changes
in four steps (bright, medium,
dim and off) by pressing the
main unit’s DIMMER button repeatedly.
(Remote
control unit)
1
Display
IN=V SOURCE
(Remote
control unit)
(Remote
control unit)
1
2