Denon AVR-1905, Руководство по эксплуатации

Страница: 12 / 85

12
ENGLISH
Before setting up the system
4
Press the SYSTEM SETUP button to enter the
setting.
*SYSTEM SET UP
3
Turn on the power.
Press the Power ON/STANDBY switch (button).
ON / STANDBY
(Main unit)
NOTE: Please make sure the “AUDIO” position of
the slide switch on the remote control unit.
5
Press the ENTER or (down) button to switch to the Speaker Configuration
Setup.
NOTE:
• Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at any time.
The changes to the settings made up to that point are entered.
2
Press the Power switch (button).
ON OFF
(Main unit)
• ¢ ON
The power turns on and indicator is light.
Set the power switch to this position to turn the power on and off from the
included remote control unit.
• £ OFF
The power turns off and indicator is off.
In this position, the power cannot be turned on and off from the remote control
unit.
1
Refer to “CONNECTIONS” (pages 5 to 9) and check that all connections are correct.
(Remote control unit)
(Remote control unit)
(Remote control unit)
Setting the type of speakers
1
Set whether or not speakers are connected and, if so, their size parameters.
1 FRONT LARGE
2
Press the ENTER or (down) button to enter the settings and switch to the
SPEAKER DISTANCE setting.
• Set up in function of your speaker systems. Performing this setup optimizes the system.
• The composition of the signals output to the different channels and the frequency response are adjusted
automatically according to the combination of speakers actually being used.
Center Sp. Front Sp. Front Sp.
Listening position
Surround back Sp.
Subwoofer
Surround Sp.
Surround Sp.
• To select the parameter
• Parameters
Large.................Select this when using speakers that have sufficient performance for reproducing bass sound
below the frequency set for the Crossover Frequency mode.
Small .................Select this when using speakers that do not have sufficient performance for reproducing bass
sound below the frequency set for the Crossover Frequency mode. When this is set, bass
sound with a frequency below the frequency set for the Crossover Frequency mode is sent
to the subwoofer.
None .................Select this when no speakers are installed.
Yes/No...............Select “Yes” when a subwoofer is installed, “No” when a subwoofer is not installed.
2spkrs/1spkr .....Set the number of speakers to be used for the surround back channel.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when
“Small” is set for the front, center and surround speakers.
(Remote control unit)
(Remote control unit)
• To select the speaker
(Remote control unit)