10
ENGLISH
Before setting up the system
2
Press the SYSTEM SETUP button to enter the setting.
*SYSTEM SET UP
1
Check that all the components are correct, then press the POWER
operation switch on the main unit to turn on the power.
(Main unit)
NOTE:
Please make sure the “AUDIO” position of the slide switch on the
remote control unit.
3
Press the ENTER or
(down) button to switch to the speaker
configuration set up.
NOTE:
Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at
any time. The changes to the settings made up to that point are entered.
Setting the speaker configuration
1
Use the
(left) and
(right) buttons to select your front speaker type.
1 FRONT LARGE
LARGE
SMALL
(Initial)
(left) button
(right) button
Press the ENTER or
(down) button to switch to the center speaker setting.
2
Use the
(left) and
(right) buttons to select your center speaker type.
2 CENTER SMALL
LARGE
SMALL
NONE
(Initial)
(left) button
(right) button
Press the ENTER or
(down) button to switch to the surround speaker
setting.
NOTE:
When “Small” has been selected for the front speakers, “Large” cannot be selected for the center
speaker.
3
Use the
(left) and
(right) buttons to select your surround speaker type.
3 SURR. SMALL
LARGE
SMALL
NONE
(Initial)
(left) button
(right) button
Press the ENTER or
(down) button to switch to the subwoofer setting.
NOTE:
When “Small” has been selected for the front speakers, “Large” cannot be selected for the
surround speakers.
4
Use the
(left) and
(right) buttons to select your subwoofer setting.
4 S.WOOFER YES
YES
NO
(Initial)
(left) button
(right) button
Press the ENTER or
(down) button to enter the settings and switch to the
Subwoofer mode setting.
•
Parameters
Large…… Select this when using speakers that can fully reproduce low sounds of below 80 Hz.
Small…… Select this when using speakers that cannot reproduce low sounds of below 80 Hz with sufficient
volume. When this setting is selected, low frequencies of below 80 Hz are assigned to the
subwoofer.
None…… Select this when no speakers are installed.
Yes/No…. Select “Yes” when a subwoofer is installed, “No” when it’s not installed.
NOTE:
Select “Large” or “Small” not according to the physical size of the speaker, but according to the bass
reproduction capacity at 80 Hz. If you cannot determine the best setting, try comparing the sound when set to
“Small” and when set to “Large”, at a level that will not damage the speakers.
Caution:
In case the subwoofer is not used, be sure to set “Subwoofer = No”, or the bass sound of front channel is
divided to subwoofer channel and not reproduced in some mode.
Setting the Subwoofer mode
1
Use the
(left) and
(right) buttons to select the Subwoofer mode.
5 SW MODE NORM
NORM
+MAIN
(Initial)
(left) button
(right) button
Press the ENTER or
(down) button to enter the setting and switch to the
Speaker distance setting.
Содержание AVR-1404/484
Страница 90: ...90 MEMO...
Страница 91: ...91 MEMO...
Страница 92: ...16 11 YUSHIMA 3 CHOME BUNKYO KU TOKYO 113 0034 JAPAN Telephone 03 3837 5321 Printed in China 511 4060 106...