Denon 5805 - AVR AV Receiver, Руководство по эксплуатации

Страница: 22 / 214

22
Easy Setup and Operation
Starting Auto Setup
2
Press the
CURSOR
D D
or
H H
button to select
“Auto Setup / Room EQ”, then press the
ENTER
button.
• The “Auto Setup / Room EQ” menu appears.
1
Press the
SYSTEM SETUP
button.
• The “System Setup Menu” appears.
4
Press the
ON/STANDBY
switch on the main
unit or
ON
button on the remote control unit.
• When pressed, the power turns on and the display
lights.
• When pressed again, the power turns off, the
standby mode is set and the display turns off.
The sound is muted for several seconds, after which
the unit operates normally.
Whenever the
ON/STANDBY button is in the standby
state, the apparatus is still connected to the AC line
voltage. Please be sure to turn off the
POWER switch or
unplug the cord when you leave home for, say, a
vacation.
5
Press the
AMP
button to select “AMP” (only
when operating with the remote control unit).
3
Press the
CURSOR D D
or
H H
button to select
“Auto Setup”, then press the
ENTER
button.
• The “Auto Setup” screen appears.
The message “Connect Microphone” is displayed if no
microphone is connected. If so, connect the auto setup
microphone.
3
Press the
POWER
switch.
£ OFF:
The power turns off and indicator is off.
In this position, the power cannot be turned on and
off from the remote control unit.
¢ ON:
The power turns on and the power indicator lights.
Set the
POWER switch to this position to turn the
power on and off from the included remote control
unit.
1
Turn on your subwoofer.
Set the volume to halfway and set the crossover
frequency to the maximum or Low pass filter off if your
subwoofer can adjust the output volume and the
crossover frequency.
Some subwoofers have a standby mode. Be sure to
turn this function off before performing the Auto Setup
procedure.
2
Turn on your TV (monitor).
Turning on the power
• If no operation is performed for approximately 3 minutes
during the auto setup procedure, the screensaver is
launched. The screensaver is canceled if any one of the
CURSOR , ENTER or SYSTEM SETUP button is pressed.