Denon 5805 - AVR AV Receiver, Руководство по эксплуатации

Страница: 123 / 214

123
Advanced Setup – Part 1
• When adjusting the level of an active subwoofer system,
you may also need to adjust the subwoofer’s own volume
control.
• When you adjust the channel levels while in the SYSTEM
SETUP CHANNEL LEVEL mode, the channel level
adjustments made will affect all surround modes for ZONE2.
• After you have completed the SYSTEM SETUP CHANNEL
LEVEL adjustments, you can then activate the individual
surround modes and adjust channel levels that will be
remembered for each of those modes. Then, whenever you
activate a particular surround sound mode, your preferred
channel level adjustments for just that mode will be recalled.
Check the instructions for adjusting channel levels within
each surround mode (
page 95, 96).
• You can adjust the channel levels for each of the following
surround modes for ZONE2: STEREO, STANDARD
(DOLBY/DTS SURROUND), 5/7 CH STEREO, WIDE
SCREEN, SUPER STADIUM, ROCK ARENA, JAZZ CLUB,
CLASSIC CONCERT, MONO MOVIE, VIDEO GAME,
MATRIX and VIRTUAL.
2
Press the
CURSOR F F
or
G G
button to select the
frequency.
VARIABLE 40, 60, 80, 100, 120, 150, 200, 250 Hz:
Set as desired according to your speakers’ bass
playback ability.
3
Press the
ENTER
button to enter the setting.
• The “Zone Setup” menu reappears.
Setting the Crossover Frequency for ZONE2
• Set the frequency (in Hz) below which deep bass appearing
in the main channels will be routed to the ZONE2 subwoofer.
1
Press the
CURSOR D D
or
H H
button to select
“Crossover Frequency” at the “Zone Setup”
menu, then press the
ENTER
button.
• The “Crossover Frequency” screen appears.
• For the majority of home theater speaker systems, we
recommend that the crossover frequency be set to 80 Hz.
When using very compact speakers, however, it may be
advantageous to select a higher crossover frequency. Check
the specified low frequency limit of each speaker (usually
published in the specifications tables in speaker owner’s
manuals).
• The crossover frequency mode is valid only when subwoofer
is set to “Yes”, and when one or more speakers are set to
SMALL, as described in section “Setting the type of
speakers for ZONE2” (
page 120).
3
Press the
CURSOR D D
or
H H
button to select the
ZONE2 input source, then press the
CURSOR
F F
or
G G
button to select “ON” or “OFF”.
ON:
When there are multiple input signals for the input
sources selected at ZONE2, the input signal is
detected and the input signal output to the
ZONE2’s monitor output terminal is selected
automatically, in the following order of priority:
Component, S-Video, Composite.
Setting the Video Setup for ZONE2
1
Press the
CURSOR D D
or
H H
button to select
“Video Setup” at the “Zone Setup” menu, then
press the
ENTER
button.
• The “Video Setup” screen appears.
2 Video Convert Mode (ZONE2)
• This sets whether or not to use the video conversion
function.
2
Press the
CURSOR D D
or
H H
button to select
“Video Convert Mode”, then press the
ENTER
button.
• The “Video Convert Mode” screen appears.
OFF:
The convert function does not operate.
In such cases, the input device’s cable type must
be the same as the type of cable connected to the
AVR-5805CI’s monitor output terminal (video, S-
Video or component video).
4
Press the
ENTER
button to enter the setting.
• The “Zone Setup” menu reappears.