Denali M1, Руководство пользователя

Страница: 12 / 31

D
ENALI
M1 52-13382-1
S
OLID
S
TATE
C
OOLING
S
YSTEMS
, 167 M
YERS
C
ORNERS
R
OAD
, W
APPINGERS
F
ALLS
, NY 12590
T
ELEPHONE
: (845) 296-1303 F
AX
: (845) 296-1303
WEB
:
WWW
.
SSCOOLING
.
COM
R
EVISION
E1
9
S
ECTION
5
O
PERATION
____________________________________________________
The chiller is operated via the control panel located on the top of the
unit. The control panel has an 8-character LCD display and three
input keys: UP, DOWN, and ENTER. These keys work as follows:
Key
Action
UP Pressing the UP key raises the parameter value displayed.
DOWN Pressing the DOWN key lowers the parameter value displayed
ENTER Pressing the ENTER key momentarily enters the parameter changed.
ENTER Pressing and holding the ENTER key for 3 seconds changes the LCD display menu.
5.1 S
IMPLE
O
PERATION
The Denali M1 comes with preset operating parameters that will
work well for most applications. If temperature control at one
temperature is desired, follow the steps below.
1)
Turn on chiller and wait for display to read TEMP: XX.X°C
2) Press the UP or DOWN keys to change SETTEMP1 to the
desired set point.
3) Press the ENTER key.
The chiller will now control to the set point temperature. To
change the set point temperature just press the UP or DOWN
keys again to change SETTEMP1 to the new set point, followed
by the ENTER key.
5.2 A
DVANCED
O
PERATION
The Denali M1 has two menus: the Status Menu and the Parameter
Input Menu. The Status Menu shows the current temperature of
coolant leaving the chiller (see Figure 4). The Status Menu also
allows input of new coolant temperature set points when the cycling
feature is off. The Parameter Input Menu allows input of set point
temperatures, soak times, number of cycles if cycling between two
temperatures, an alarm temperature, a temperature offset, and a
password to enter the Parameter Input Menu. (The default password
is 0000 until changed by the user.) Press and hold the enter key for 3
seconds to enter the parameter menu.
Note: While in the Parameter Input Menu, if no keys are pressed for
30 seconds the display will revert to the status menu.