5.3 - Tapping Factory Turn Signals
DENALIELECTRONICS.COM
5. Alternate Wiring Options
(Continued)
If you already have other devices on your CANsmart and only have two circuits
available, you can use the motorcycle’s factory turn signal wires for the turn signal
input.
Step One:
Remove the connector from the longest lead of the harness and then
use a posi-tap connector to tap the factory left side turn signal positive wire.
Step Two:
Connect the third longest lead of the harness to the Yellow circuit of
the CANsmart.
Step Three:
Connect the second shortest lead of the harness to the Blue
circuit of the CANsmart.
5.2 - Wiring For Front T3 Pods Only
If configuring for an installation of just front T3 pods, follow the steps listed
below.
Step One:
Connect the longest lead of the harness to the White circuit of the
CANsmart.
Step Two:
Connect the second longest lead of the harness to the Yellow
circuit of the CANsmart.
Step Four:
Connect the shortest lead of the harness to the Red circuit of
the CANsmart.
Step Four:
Remove the connector from the shortest lead of the harness and
then use a posi-tap connector to tap the factory right side turn signal positive
wire.
Note:
The unused Blue Circuit can be used to control an additional device of
your choosing.
