1. Harness Overview
1.1 - Overview of Harness
DENALIELECTRONICS.COM
2.1 - CANsmart Connections
Follow the steps in this section to configure the harness for installation of a
set of four T3 lights; two rear T3 pods & two front T3 pods. If configuring for
an installation of just front or rear T3 pods follow the steps listed in
Section 5.
Step One:
Connect the longest lead of harness to the White circuit of the
CANsmart.
Step Two:
Connect the second longest lead of the harness to the Yellow
circuit of the CANsmart.
Step Three:
Connect the third longest lead of the harness to the Blue circuit
of the CANsmart.
Step Four:
Connect the shortest lead of the harness to the Red circuit of
the CANsmart.
The DENALI CANsmart™ Wiring Harness for T3 Switchback Signals provides
plug-n-play installation of four T3 Pods to the CANsmart™ Controller.
Compatible with all GEN II DENALI CANsmart™ Controllers, no wire tapping or
other modifications are necessary, just plug directly into the circuits of the
CANsmart to send the signals from your controller to the T3 Lights. This
harness is designed to power a set of four T3 lights; two rear T3 pods & two
front T3 pods, but can also be configured for an installation of just front or rear
T3 pods as well.
Rear Right T3
Front Right T3
Front Left T3
Rear Left T3
Front T3 Extension
CANsmart Red Circuit
CANsmart Blue Circuit
CANsmart Yellow Circuit
CANsmart White Circuit
2. Connecting To CANsmart Controller
