3. Configuring CANsmart Controller
DENALIELECTRONICS.COM
3.1 - Configure CANsmart Using Software
The CANsmart Accessory Manager will be used to configure your controller
for operation of the T3 signals, for further details of how to use the
software refer to the manual that was provided with your CANsmart
Controller.
Step One:
Use the Circuit Function Selector to configure each of the four
circuits as shown above.
(Red Circuit=Left Turn, Blue Circuit=Brake Light, Yellow
Circuit=Light Pair 1, White Circuit=Right Turn)
Step Two:
In the Auxiliary Lights One panel, disable “Three-Wire dimming
Mode”.
Step Three:
In the Turn Signal panel, set the running light intensity to 0%.
The remainder of the settings can be configured as desired, but it is important
the settings made in steps one through three are not changed or the lights will
not function properly.
Note:
If installing just front T3 pods, you do not need to set the Blue Circuit to
Brake Light. Likewise, if installing just rear T3 pods, you do not need to set the
Yellow Circuit to Light Pair One. The unused circuit can be configured to any
circuit function to power another accessory.
