5. Alternate Wiring Options
4. Wiring The Lights
DENALIELECTRONICS.COM
5.1 - Wiring For Rear T3 Pods Only
4.1 - Routing The Harness
Once the connections to the CANsmart Controller have been made and the
software has been configured you will need to identify the left side and
right side T3 lights.
Step One:
If installing front T3 pods, connect the Front T3 Extension to
the long lead of the harness and begin routing the harness towards the
mounted front pods, then connect the pods to the end of the extension.
Step Two:
If installing rear T3 pods, begin routing the lead from the rear
pods towards the harness and then
connect the pods to the two short leads
of harness.
Step Three:
With the motorcycle’s ignition on, activate each side turn signal
and make sure the T3 pods are flashing on the correct side of the vehicle. If
incorrect, simply swap the connections or remount the pods on the other side
of the vehicle.
If configuring for an installation of just rear T3 pods follow the steps listed
below.
Step One:
Connect the longest lead of the harness to the White circuit of the
CANsmart.
Step Two:
Connect the third longest lead of the harness to the Blue circuit of
the CANsmart.
Step Three:
Connect the shortest lead of the harness to the Red circuit of
the CANsmart.
Note:
The unused Yellow Circuit can be used to control an additional device
of your choosing.
Front Right T3
Front Left T3
CANsmart
Rear Left T3
Rear Right T3
Front T3 Extension
Harness
