2. Connecting To CAN bus
3. Connecting Accessories
3.1 - Light Set One & Two (Red & White Circuits)
DENALIELECTRONICS.COM
In the default configuration, the circuit for Light Set One is the longest red
lead, the shortest white lead is for Light Set Two. Both circuits are designed
to handle up to 10 amps each.
Step One:
Plug the male 3-pin connector of the Light Extension-Splitter
into one of the CANsmart™ Controller’s light circuits.
Step Two:
Begin routing the harness toward the front of the bike. Secure
the harness to the vehicle’s frame along the way with the included zip ties.
Be sure to avoid any moving components such as radiator fan blades or
suspension.
Step Three:
Plug the DENALI Light Pods into the female 3-pin connec-
tors of the Extension-Splitter. Repeat steps
One
through
Three
using a
second Light Extension-Splitter for the second set of lights.
Two-Wire Dimming:
Turn off “Three-Wire Dimming Mode” for correct
dimming operation of auxiliary LED lights that have only two wires. If
enabled the 3rd yellow wire will be deactivated and PWM data will
instead be transmitted through the red wire.
Wire two wire lights using the red wire for positive (+) and the black
wire for negative (-).
2.1 -
Bikes With Anti-Theft Alarm System
Step One:
The DWA unit is located at the rear of the motorcycle in the
compartment behind the passenger seat. Remove the seat and body
panels in this area to gain access to the unit.
Step Two:
Unplug the connector from the DWA unit.
Step Three:
The CANsmart™ Controller plugs in-line between the
motorcycle’s harness and the DWA unit. First plug the DWA connector
into the male 8-pin connector on the CANsmart™ Controller.
Step Four:
Plug the female 8-pin connector on the CANsmart™
Controller into the DWA unit.
2.2 -
Bikes Without Anti-Theft Alarm System
Step One:
The DWA connector is located at the rear of the motorcycle
in the compartment behind the passenger seat. Remove the seat and
body panels in this area to gain access to the connector.
Step Two:
Remove the cap from the DWA connector.
Step Three:
Plug the DWA connector into the male 8-pin connector on
the CANsmart™ Controller.
Step Four:
Use the cap that was previously removed to cover the
unused female 8-pin connector on the CANsmart™ Controller.
DWA Unit
Cap
DWA Connector
DWA Connector
Light Extension
Light Extension
Light Set Two
Light Set One
