Deltronic Labs Ticket Eater D2000, Руководство пользователя

Страница: 26 / 50

TT-2000 Ticket Eater
™
by Deltronic Labs June 2015
26
YES
NO
NO
YES
NO
YES
NO
Does the motor run at power
up before inserting tickets?
1. Check the position of the front
sensor.
2. Check the connection between the
sensor board and the logic board.
3. Check the leads on the front sensor.
4. Check the drive transistor and LED
for the front sensor.
Insert a strip of 10 to 20
tickets. Does it cut okay?
Turn off the machine. Remove the
cutter and guide assemblies, clean
them, and replace.
Cutter Assembly checks:
1. Build up on the blade
2. Cutter tight on the flat of the shaft.
3. Gear tight on the shaft.
4. Paper stuck in the housing.
5. Stationary blade adjustment.
6. Proper seating of the cutter assembly
in the guide housing assembly.
Guide Assembly checks:
1. Roller spring tension.
2. Roller spring screws tight.
3.
The top guide “trailing finger” should
be straight, not bent.
4. Paper stuck in guide track or entry
block.
Did it count okay? No count at all:
1. Check the holes-only / barcode
setting.
2. Re-learn the barcode.
Miscount:
1. Clean dust off the sensors.
2. Check that the sensors hanging
below the sensor board are not
shoved off center.
3. Reposition the guide assembly.
4. Check the roller spring shape and
tension (see mechanical drawings).
Print receipt okay?
Make sure paper is loaded properly.
Note that thermal paper only prints on
one side. It will be blank if loaded
backwards.