Deltronic Labs Ticket Eater D2000, Руководство пользователя, Страница: 19 / 50

TT-2000 Ticket Eater
™
by Deltronic Labs June 2015
19
8. Re-install the cutter assembly in the machine. Make sure that it is seated all the
way down so that its gear meshes correctly with the gear on the guide housing
assembly.
Stationary Blade Replacement
The Ticket Eater blade has two edges. When one edge has worn to the point that it can
not be adjusted, it can be flipped around to use the other edge. To flip the blade or
replace the blade, follow these steps:
1. Make sure the
POWER IS OFF
and the cutter is not rotating.
2. Pull straight up to remove the cutter assembly from guide housing assembly
3. Set the cutter assembly on a spacer or the edge of your workbench so that you can
access the blade screws and turn the flywheel.
CAUTION:
Even a dull blade is sharp enough to cut your fingers. Keep them
away from the cutter and the blade.
4.
Use a 7/64” hex wrench to remove the screws that hold the stationary blade (see
photo on previous page).
5. Remove the blade, but leave the adjustment screws in place.
6. Flip the blade around to use the other edge, or use a new blade. Install the blade
being careful not to get the bevel backwards. The wider side of the blade should
be against the frame.
7. Follow the instructions on the previous page to adjust the blade.