Delta SVG300A43A-11, Быстрая звезда

Страница: 61 / 127

III
Installation Checklist
The following table provides installation details so as to enable quick and convenient assembly by to a
professional electrical engineer. These steps can prevent human errors that cause unnecessary harm.
NOTE
Only qualified electrical engineers should adjust the equipment. Carefully read and follow the manual's Before You Start safety
instructions. Ignoring the safety instructions can cause injury or death.
Installation of Equipment
□ Is the equipment being installed in a well ventilated, indoor area with a relative humidity of less
than 90% without condensation?
□ Is the operating environment temperature maintained at -10~45°C (SVG300AXXA-XX model);
-10~40°C (SVG500AXXA-XX model)?
□ Installation Complies with Degrees of Pollution: Degree 2 (for a factory environment) and
contamination-free substances without e-waste contaminated dust particles.
□ The location of the equipment must be approved for fire safety, must be clean, must not be within
the vicinity of corrosive gases, and must not vibrate.
□ Is there any weight or items stacked on top of the Static VAR Generator?
□ Is it placed on level ground?
Electrical Installation
□ The equipment is grounded
□ The equipment's input voltage value is consistent with the supply voltage
□ Is the wiring for the input terminals correct?
□ Has the power cable been properly chosen? Refer to the User Manual.
□ The input terminal must be connected to the fuse and isolation switch. Refer to the User Manual.
□ Does the voltage value of the equipment's transformer match the voltage supply?
□ Is the orientation of the CT installation correct? "Current transformer grid terminal: K (S1); Load
terminal: L (S2)"
□ Is the installation of the CT diameter and length correct? Please refer to the User Manual.
□ Confirm that there are no other conductors and assembly parts inside the Static VAR Generator
(SVG).
□ Confirm that the cover is back in place after adjusting the voltage of the transformer.
Before Starting the Device
□ Before starting the Static VAR Generator (SVG), determine whether the I/O of the power supply
relay is in an uncharged state.
□ When the power cable wiring is complete, check that the cabinet door is closed.
□ When the power cable wiring is complete, to ensure safety, do not touch the cable.
□ If the cable is exposed, please provide clear warning signs such as "Do Not Touch the Cable".