l
4
PREPARATION
Tools Required for Assembly (not included): Hammer, Flathead Screwdriver, Wire Nuts, Nails, Duct Tape,
Phillips Head Screwdriver, Utility Knife
Helpful Tools (not included): Electric Drill, Drill Bits
WARNING: Turn off electricity at breaker box before beginning installation.
• Carefully remove unit from carton.
• Before installation, provide inspection and future maintenance access at a location that will not interfere with
installation work.
• Check area above installation location to be sure that wiring can run to the planned location and that duct work
can be run. Make sure the area is sufficient for proper ventilation.
• You may need the help of a second person to install this fan: one person on the attic side and one on the room
side.
Note:
Installations may vary depending on how the previous bath fan was installed. Supplies necessary for the
installation of your bath fan are not all included. However, most are available at your local home improvement or
hardware store.
• Proper insulation around the fan to minimize building heat
loss and gain.
• Locate unit away from heating or cooling sources.
•
The fan will operate most efficiently when located where the
shortest possible duct run and minimum number of elbows
will be needed.
• Use a roof cap or wall cap that has a built-in damper to
reduce backdrafts.
• External timer/dimmer switch can be used please contact
Delta Breez customer service and consult with a licensed
electrician for compatibility.
WARNING: Remove ceiling section using dimensions provided below. Be careful to cut hole exactly. If hole
is too big, the fan grille will not hide it.
DIMENSION REQUIREMENTS
Housing
Dimension (L)
Housing
Dimension (W)
Housing
Dimension (H)
15 1/2 in.
9 1/2 in.
7 1/2 in.
