8
Fig. 9
Fig. 10
Fig. 11
ASSEMBLING
S AW TO STA N D
1.
Fig. 8, illustrates the stand (B) completely assem-
bled.
2.
Assemble rubber foot (A) Fig. 8, onto the end of
each stand leg (B). Insert grommet (C) into hole (D) i
n
s
tand leg.
3.
Carefully place saw (E) Fig. 9, onto saw stand (B).
Align eight holes in the top of stand (B) with mounting
holes in the bottom of saw (E) and fasten with eight screws,
flat washers, lockwashers, and hex nuts (F) Fig. 8.
4.
Fig. 9, illustrates the saw (E) assembled to the saw
s
tand (B). Carefully push down on the top of the saw until
the stand legs are positioned firmly on the floor surface
and securely tighten all saw and stand mounting hard-
ware. Notice that panel (G) is not only a support for a
s
tand, but also serves as a dust chute.
ASSEMBLING B L A D E
TILTING H A N D W H E E L
1.
Assemble blade tilting handwheel (A) Fig. 10, to
shaft (B). Make certain slot (C) in handwheel is engaged
with roll pin (D) on the shaft
.
2.
Thread locking lever (E) Fig. 11, onto shaft
.
3.
Fig. 11, illustrates the blade tilting handwheel (A) and
locking lever (E) assembled to the saw.
E
B
G
D
B
A
C
A
E
Fig. 8
D
B
C
A
E
F
F