11
Fig. 20
Fig. 21
Fig. 22
Fig. 23
7.
Lift the motor and assemble the drive belt (H) Fig. 20,
to the arbor pulley and motor pulley (B). The weight of
the motor will provide the correct belt tension.
8.
W ARNING: IMMEDIATELY A F T E R A S S E M B L I N G
T H E B E LT, RAISE T H E S AW B L A D E TO ITS M A X I M U M
HEIGHT A N D TILT T H E S AW B L A D E TO 45 DEGREES.
C H E C K TO S E E IF T H E M O TO R E N D BELL (J) FIG. 21,
IS B E L O W T H E TO P O F T H E TA B L E S U R FA C E (K). IF
T H E M O TO R E N D B E L L (J) IS A B O V E T H E TO P O F
THE TA B L E S U R FACE, THE M O TOR MUST B E M O V E D
TO T H E LEFT UNTIL Y O U A R E C E R TAIN T H E E N D
B E L L (J) O F T H E M O TO R IS B E L O W T H E TO P O F
T H E TA B L E S U R FACE. THEN RE-ALIGN T H E M O TO R
PULLEY TO T H E A R B O R PULLEY.
9.
Assemble the outer cover (E) Fig. 22, of the belt and
pulley guard assembly, which was removed in STEP 3,
and fasten with external tooth lockwasher and wing nut
(D). IMPORTA N T:Make certain the outer cover does not
interfere with the drive belt and the motor pulley.
CONNECTING M O TO R C O R D
TO SWITCH A S S E M B LY
W ARNING: B E F O R E CONNECTING M O TO R C O R D TO
T H E SWITCH A S S E M B LY, MAKE C E R TAIN T H E S AW
IS DISCONNECTED F R O M T H E P O W E R S O U R C E.
1.
Insert the pronged motor plug (A) Fig. 23, into the
female receptacle (B) of switch-to-motor cord (C).
H
B
K
J
D
E
C
B
A