19
Fig. 51
Fig. 52
Fig. 53
Fig. 55
Fig. 54
B
A
B
ASSEMBLING UNIFENCE
TA B L E TO S AW
1.
Position table board (A) Fig. 51, onto angle brackets
(B).
2.
While holding table board firmly against the saw
table, fasten table to three angle brackets (B) Fig. 52,
using three #8 x 7/8†long wood screws (C). CAUTION:
DO NOT OVER-TIGHTEN TA B L E MOUNTING S C R E W S.
Over-tightening screws in particle board may cause them
to strip.
3.
Using a straight edge (D) Fig. 53, make certain the
surface of the Unifence table (A) is level with the saw
table (F) by adjusting the height of the two leveling
screws (E) Fig. 54, at the base of the table legs and
adjusting the height of angle brackets (B) Fig. 55. Once
the Unifence table is level with the saw table, tighten
three hex nuts (G) Fig. 55, and position hex nuts (H)
Fig. 54, against the bottom of the table legs to hold the
leveling screws in position.
C
A
C
F
A
D
G
G
H
H
E
B
B
B
B