Delta Visione DEV7, Руководство по эксплуатации и обслуживанию

Страница: 34 / 49

DEV7
– Use and Maintenance Manual
Pag. 32
Maintenance plan
The table below lists the recommended maintenance operations and the relative frequency.
The operations described below can be carried out by an operator who has carefully read and well
understood the safety procedures and the operations to be carried out.
Group Operation Frequency
Punch
body
Cleaning and lubricating the rails . The presence of debris, dust and
machining scrap may interfere with the machine’s operation. The rails on
which the punch body drive system runs must be cleaned, taking care to
grease them adequately using the grease nipple present on the runners.
Weekly
Punch
body
Cleaning and lubricating the tip . To clean and lubricate the tip, the body
of the punch containing it must be partially disassembled: see the
instructions of the following section.
Weekly
Punch
body
Checking the wear of the tip . The wear of the marking tip depends upon
the material to be marked. The condition of the tip should be checked
periodically to guarantee a constant marking quality.
Weekly
Control
unit
Cleaning the integrated display . Wipe the display with a soft cloth.
Weekly
Machine
Complete diagnostics using the software . The integrated diagnostic
functions will be used to check the operation of the step motor, drive, etc.
Monthly
Machine
Check of the condition of the identification and registration labels .
Quarterly