28
GB/IE
Possible defects
In the following you will be shown possible defects, their causes and how to rectify them.
Defect
Possible cause
Remedy
Remote control (2) does not
respond.
Remote control (2) is switched
off.
Turn on remote control (2).
Batteries (5) incorrectly inserted. Insert the batteries (5) correctly.
Batteries (5) are dead.
Replace the batteries (5).
The drone ball (1) does not
respond.
The batteries (5) in the remote
control (2) were incorrectly
inserted or are dead.
Check the batteries (5) and
replace if necessary.
The rechargeable battery in the
drone ball (1) is flat.
Charge the rechargeable
battery.
Drone ball (1) is out of range.
Make sure that the distance
between the remote control (2)
and the drone ball (1) is not
more than 25m.
The drone ball (1) cannot be
controlled.
Too strong a wind or draught.
The drone ball (1) is only
suitable for a calm windless
environment without draught.
The drone ball must be
calibrated.
Place the drone ball (1) on a
horizontal, level surface. Slide
the throttle (2c) and the control
lever (2d) to the rear right simul-
taneously. The LED navigation
lights (1e) of the drone ball
flash for approx. 3 seconds.
Once these shine continuously,
the calibration is complete and
the drone ball is ready to fly.
Note:
Repeat the calibration if
the drone ball still flies erratical-
ly in one direction.
The drone ball (1) does not fly
upwards.
Not enough throttle.
Slowly slide the throttle (2c)
forward.
Rechargeable battery is flat.
Charge the rechargeable
battery.
