VIVOTEK
User's Manual - 425
© 2020 VIVOTEK INC. All Right Reserved
281
PARAMETER VALUE
DESCRIPTION
function getstatus
Function type
getstauts : Information of smartSD internal status return
value as below:
smartsd_lifetime_num
:
Accumulated amount of data that has been written
smartsd_lifetime_den
:
Card-guaranteed amount of data that can be written
smartsd_lifetime_rate
:
The ratio of smartsd_lifetime_num to
smartsd_lifetime_den.
It means the accumulated percentage amount of flash
block has been written. The range is from 0 to 100 (unit: %).
The SD card is recommended to be replaced if the
percentage reaches above 90%.
smartsd_spare_block_rate
:
Usage rate of spare blocks.
It means the usage percentage of total spare block. The
range is from 0 to 100 (unit: %). The SD card is
recommended to be replaced if the percentage reaches
above 90%.
smartsd_data_size_per_unit
:
Size (in sectors) of data to be written when Life
Information1 is updated.
smartsd_num_of_sudden_power_failure
:
Indicates how many times power disconnection occurred during write/erase
operations
smartsd_operation_mode
:
Enables/disables power-off detection and write error notification
smartsd_attached
:
Indicate the smartSD is attached or not.
8.30
Connect to AP
(capability_network_wireless > 0)
Note:
This request requires Administrator privileges.
Method:
GET/POST
© 2020 VIVOTEK INC. All Right Reserved
282
Syntax:
http://
<servername>
/cgi-bin/admin/connect_ap.cgi
PARAMETER
VALUE
DESCRIPTION
N/A
N/A
Apply the wireless settings and connect to AP.
8.31
Get Wireless Information
(capability_network_wireless >
0)
Note:
This request requires Administrator privileges.
Method:
GET/POST
Syntax:
http://
<servername>
/cgi-bin/admin/getwirelessinfo.cgi
PARAMETER
VALUE
DESCRIPTION
N/A
N/A
Get wireless information. Camera will return following
information.
1. Wireless channel
2. Link quality
3. Signal level
4. Noise level
5. SNR
6. TX Rate
7. RX Rate
8.32
Get Wireless Signal Strength
(capability_network_wireless
> 0)
Note:
This request requires Administrator privileges.
Method:
GET/POST
Syntax:
http://
<servername>
/cgi-bin/admin/getwlsignalstrength.cgi
Содержание Vivotek FD9189-H-V2
