3. Trim the shroud. Using a sharp utility knife or
shears, score the plastic along the cutline
with several passes, cutting a little deeper
each time. When you have cut about halfway
through the plastic, bend it back and forth
several times for a clean cut. See Figure 1.
4. Remove the video monitor and hold the
shroud in place, checking the fit.
5. Make minor adjustments, if necessary.
6. Attach DVDM-800 and shroud using screws
through the perimeter screw bosses. Use
spacers provided to support shroud as
required. Do not overtighten. This can cause
the assembly to distort or bend. See Figure 2.
Use of screw locking compound recommended.
7. If using the mounting bracket, secure it to the
roof support cross-members.
8. Attach DVDM-800 (alone or as part of the
shroud assembly). The bolts should contact
the roof support cross-members directly
with no gap between the bolt and the roof
structure. Be sure that bolts do not pierce
the outer roof skin when fully fastened to the
cross-member.
Roof
Roof support
Headliner
Roof
Roof support
Headliner
Mounting bracket
(if used)
Mounting bracket
Shroud
DVDM-800
DVDM-800
5
Warning: Failure to properly follow these instructions
could result in damage to the vehicle, its electronic system,
other property, or personal injury and/or death.
Figure 1.
Figure 2.
With Shroud
Without Shroud
