DèLonghi Esam6900, Инструкция по эксплуатации

Страница: 20 / 29

19
4. Replace the drip tray complete with grounds container;
5. Close the service door.
Cleaning the inside of the machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned off
(see “Turning off”) and unplugged from the mains power sup-
ply. Never immerse the coffee machine in water.
1. Check regularly (about every 100 coffees) that the inside
of the appliance (accessible after removing the drip tray)
is not dirty. If necessary, remove coffee deposits with the
brush supplied and a sponge.
2. Remove the residues with a vacuum cleaner (fig. 45).
Cleaning the water tank
Clean the water tank about once a month and whenever you
replace the water softener filter (if present) as follows:
1. Remove the filter.
2. Clean the water tank with a damp cloth and a little mild
washing up liquid. Rinse with running water.
3. Rinse the filter (if present) and put back in the water tank.
Fill the tank with fresh water and put back in the appliance.
Cleaning the coffee spouts
46
1. Clean the coffee spouts
with a sponge or cloth.
2. Check the holes in the
coffee spout are not
blocked.
If necessary, remove
coffee deposits with a
toothpick (fig. 46).
Cleaning the pre-ground coffee funnel
Check regularly (about once a month ) that the pre-ground cof-
fee funnel is not blocked.
If necessary, remove coffee deposits with the brush supplied.
Cleaning the infuser
The infuser (A12) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see “Turning
off”).
2. Open the service door (fig. 42).
3. Remove the drip tray and grounds container (fig. 43).
47
4. Press the two red release
buttons inwards and at the
same time pull the infuser
outwards (fig. 47) .
Important!
RINSE WITH WATER ONLY NO WASHING UP LIQUID - NO DISH
WASHER
Do not use washing up liquid to clean the infuser as it could
cause damage.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
6. After cleaning, replace the infuser by sliding it onto the in-
ternal support and pin at the bottom, then push the PUSH
symbol fully in until it clicks into place.
48
Please note!
If you encounter difficulty inserting the infuser, before inserting
it you must adapt it to the right dimension by pressing it force-
fully from the bottom and top as shown in fig. 49.
49 50
7. Once inserted, make sure the two red buttons have snap-
ped out (fig. 50).
8. Replace the drip tray and grounds container.
9. Close the service door.
Please note!