DèLonghi ECAM35X.75, Инструкция по эксплуатации

Страница: 25 / 27

24
21. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM POSSIBLE CAUSE REMEDY
The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
The internal circuits of the appliance have
cooled down because 2/3 minutes have
elapsed since the last coffee was made. Before making coffee, rinse the internal circuits
by pressing the
button (B5).
A low coffee temperature is set. Set a higher coffee temperature in the menu.
The coffee is weak or not
creamy enough. The coffee is ground too coarsely. Turn the grinding adjustment dial (A5) one
click anticlockwise towards 1 while the coffee
mill is in operation (fig. 7). Continue one click
at a time until coffee delivery is satisfactory.
The effect is only visible after delivering 2
coffees (see section “10.1 Adjusting the coffee
mill”).
The coffee is unsuitable. Use pre-ground coffee for espresso machines.
The coffee is delivered too
slowly or a drop at a time. The coffee is ground too finely. Turn the grinding adjustment dial (A5) one
click clockwise towards 7 while the coffee mill
is in operation (fig. 7). Continue one click at a
time until coffee delivery is satisfactory. The
effect is only visible after delivering 2 coffees
(see section “10.1 Adjusting the coffee mill
”).
The appliance will not make
coffee The appliance has detected impurities in its
internal circuits. "Please wait" is displayed. Wait for the appliance to be ready for use again
and reselect the required beverage. Contact
Customer Services if the problem persists.
Coffee does not come out of
one or both of the spouts. The coffee spouts (A9) are blocked. Clean the spouts with a toothpick (fig. 24B).
The appliance does not come
on It is not plugged into the mains socket. Plug into the mains socket (fig. 1).
The main switch (A22) is not turned on. Place the main switch in the I position (fig. 2).
The power cord (C7) connector is not inserted
correctly. Insert the connector as far as it will go in the
socket at the back of the appliance (fig. 1).
The infuser cannot be
extracted The appliance has not been turned off correctly Turn the appliance off by pressing the
button (A7) (fig. 6) (see section “7. Turning the
appliance off”).
At the end of descaling, the
appliance requests a third
rinse During the two rinse cycles, the water tank has
not been filled to the MAX level. Follow the instructions displayed by the appli-
ance, but first empty the drip tray to avoid the
water overflowing.
The milk does not come out of
the milk spout (D5) The lid (D2) of the milk container lid is dirty Clean the milk container lid as described in the
section “15. Descaling”.
The milk contains large
bubbles and squirts out of
the milk spout (D5) or there is
little froth The milk is not cold enough or is not
semi-skimmed. Use skimmed or semi-skimmed milk at refrig-
erator temperature (about 5° C). If the result is
not as you wished, try changing brand of milk.
The froth adjustment dial (D1) is incorrectly
adjusted. Adjust following the instructions in section “
• Espresso macchiato;”.
The milk container lid (D2) or froth adjustment
dial (D1) is dirty Clean the milk container lid and dial as de-
scribed in section “15. Descaling”
.
The hot water connection nozzle (A8) is dirty Clean the connection nozzle as described in
section . “14.11 Cleaning the hot water nozzle
” .