DèLonghi ECAM35X.75, Инструкция по эксплуатации

Страница: 24 / 27

23
Descale
ESC to cancel
OK to descale
(
∼
45 minutes)
The machine must be descaled. The descaling procedure described in section
“15. Descaling” needs to be performed.
Replace filter
ESC to cancel
OK to replace The water softener filter (C4) is exhausted. Replace the filter or remove it as described in
section “17. Water softener filter”.
General alarm The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section “14. Cleaning”. If the
message is still displayed after cleaning, con-
tact a service centre.
The tubes inside the milk container (D) must
be cleaned. Turn the froth adjustment dial (D1) to CLEAN
(fig. 19).
The water softener filter (C4) is exhausted and
must be replaced or removed. Replace the filter or remove it as described in
section “17. Water softener filter”.
The machine must be descaled. The descaling procedure described in section
“15. Descaling” needs to be performed.
The appliance may request descaling cycles at
very short intervals. This is normal and due to
the appliance’s advanced control system.
E
Energy saving is enabled. To disable energy saving, proceed as described
in section “8.5 General” - “•Energy saving:”
Add pre-ground coffee The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel (A4). Place pre-ground coffee in the funnel (fig. 11)
or deselect the "pre-ground" function.
A LONG coffee with pre-ground coffee has
been requested Put one level measure of pre-ground cof-
fee into the pre-ground coffee funnel (A4)
and press OK (B3) to continue and complete
preparation.
Fill beans container The coffee beans have run out. Fill the beans container (A3) (fig. 8).
The pre-ground coffee funnel (A4) is clogged. Empty the funnel with the help of the brush
(C5) as described in section “14.8 Cleaning the
pre-ground coffee funnel”.
Ground too fine
Adjust mill The grinding is too fine and the coffee is deliv-
ered too slowly or not at all. Repeat coffee delivery and turn the grinding
adjustment dial (A5) (fig. 7) one click clockwise
towards 7 while the coffee mill is in operation.
If after making at least 2 coffees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see section “10.1
Adjusting the coffee mill”. If the problem per-
sists, make sure the water tank (A17) is fully
inserted.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery. Insert the hot water spout (C6) in the appli-
ance and deliver a little water until the flow
becomes regular.
Less coffee Too much coffee has been used.
Select a lighter taste by pressing (B7) or
reduce the quantity of pre-ground coffee.
Insert water spout The hot water spout (C6) is not inserted or is
inserted incorrectly. Fully insert the hot water spout (fig. 4).
Insert milk container The milk container (D) is not inserted correctly. Insert the milk container as far as it will go (fig.
16).
Insert infuser assembly The infuser (A20) has not been replaced after
cleaning. Insert the infuser as described in section “14.9
Cleaning the infuser”.
Water circuit empty
Fill water circuit
Hot water
Confirm?
The water circuit is empty. Press
OK
(B3) to deliver water from the spout
(C6) until it flows out normally. If the problem
persists, make sure the water tank (A17) is fully
inserted.
Press OK to CLEAN The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position. To proceed with the CLEAN function press OK
or turn the froth adjustment dial to another
position.
Set dial to CLEAN
ESC to cancel Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned. Turn the froth adjustment dial (D1) to CLEAN
(fig. 19).
Turn froth adjustment dial The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position. Turn the froth adjustment dial to one of the
milk froth positions.