14
15
NOTE:
This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. lf this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
Modifications not approved by the party responsible
for compliance could void user’s authority to operate
the equipment.
CAN ICES-3 (B) / NMB-3 (B)
PROBLEM
CAUSE
SOLUTION
PF
display
Temperature sensor is not working
properly
The product needs to be serviced,
contact our toll free number for
assistance
Product doesn’t turn on
Check that the plug is connected to
the outlet
Auto-start is on
Room temperature reaches the set
temperature
Plug in
Wait till time elapsed or press the but-
ton (E) twice to cancel the auto-start
and push the button (A)
Use the “+” button to increase the set
temperature
A green dot is flashing and unit is off
The tip-over switch has been activated Make sure the appliance is standing
upright on a flat surface, if the problem
persists contact our toll free number to
assist you
The display shows "
H
t
" blinking
The internal temperature is too high.
The air intake or outlet grille is
obstructed
Check the appliance is correctly
positioned respecting the minum
distances from the wall, or objects, as
indicated on the instruction manual,
if not, position the appliance correctly
Remove the obstruction
Disconnect the plug from the outlet
and let the appliance cool down. After
few minutes plug the appliance again.
If the appliance doesn't work please
contact the De longhi toll free number
TROUBLESHOOTING
Содержание HFX60V15CA
Страница 2: ...2 FR EN page 4 page 10...
Страница 3: ...3 G D E F B C A I H A B C D E F...
Страница 16: ...www delonghi com 5711413251_02 _0818 Printed in China Imprim en Chine...