Electric convector heater
5
Maintenance
Always unplug from the mains socket before cleaning.
The convector heater requires no special maintenance. It is sufficient
to remove dust with a soft dry cloth. Clean when cold only.
Never use abrasive powders or solvents.
Warnings
- Do not use the heater in a bathroom or in the vicinity of bathtubs, wash
basins, showers or swimming pools.
- Never use the heater to dry laundry.
- Only use the heater in an upright position.
- The heater must be positioned at least 50cm from walls, curtains, furniture
or other objects.
- The first time you use the appliance, operate it for at least 15 minutes with
the thermostat at maximum to eliminate the “new” smell. A little smoke
due to the protective substances applied to the heating element before
transport may be given off.
- If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
- Do not use this appliance in rooms which have a floor area smaller than
4m
2
as this may lead to overheating.
- The heater must never be placed immediately under a fixed mains socket.
- Never obstruct the heaters intake and outlet grilles as this could cause dan-
gerous overheating.
-
IMPORTANT:
Never for any reason cover the appliance during opera-
tion as this could lead to dangerous overheating.
- The use of an extension lead is not recommended, as overheating of the
extension lead may occur during the operation of the heater.
-
CAUTION:
In order to avoid a hazard due to inadvertent resetting
of the thermal cutout, this appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by the utility.
- As with any electrical appliance, whilst the instructions aim to cover as many
eventualities as possible,caution and common sense should be applied when
operating your appliance, particularly in the vicinity of young children.
A safety device intervenes and turns off the appliance in the event of over-
heating or because the appliance is positioned in a strong draught of air. To
reactivate it, remove the plug from the electrical outlet, allow the appliance to
cool (about 30’),remove the cause of the overheating/draught and then recon-
nect the appliance to the mains and turn it back on. A number of models have
a special device to cut off current if the unit is overturned, placed at an angle
or knocked.An acoustic warning indicates the problem.
WARNING:
In order to avoid overheating, never under any
circumstances cover the appliances during operation,as this
would lead to dangerous overheating.
CAUTION:
In order to avoid a hazard due to inadvertent resetting of
the thermal cutout, this appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit that
is regularly switched on and off by the utility.
Содержание HCO series
Страница 7: ...5713005900 09 06...
