Electric convector heater
3
Thank you for choosing this electric convector heater.
To get the very best out of your new electric convector heater it is
advisable to read these instructions before using the appliance. This
is the only way to ensure optimum results and maximum safety.
General instructions
Remove the heater from the packaging.
Check that neither the heater nor the power cable has been damaged in
any way during transportation. Do not operate the heater if damaged.
Electrical connection
-
Before plugging the electric convector heater into the mains, check
that your supply voltage is the same as that shown on the rating
plate of the appliance.
-
If using more than one appliance at a time, it is important to ensure that
the ring main is adequate to cope with the power requirements.
- It is important to ensure that the socket is adequately earthed.
- This appliance complies with EEC Directive 89/336 relating to elec-
tromagnetic compatibility.
How to use it
To fit the feet, proceed as follows:
Insert the foot into the guide on the side and push as far as it will go until
the two teeth hook in place (fig. 1).
Wall mounting
IMPORTANT:
Before drilling into any wall ensure no electrical cables
are present in the area.
In order to wall mount your convector please proceed as follows:
1. Fix two brackets “
D
” following carefully the dimensions as indicated
in fig.3. Use a 6 mm masonry drill and use the wall plugs and screws
provided or suitable wall plugs for your type of wall.
2. Hang the convector on the two brackets fixed to the wall and
insert metal brackets “
E
” into the bottom rear section of the base
of the convector as indicated in figure
4
, one at each end.
Mark the positions for fixing these brackets to the wall.
This bracket when fixed retains the base of the convector in a fixed
position, preventing removal.
3. Remove the convector heater from the hanging brackets and drill
the wall for 2 x suitable wall plugs and insert them.
4. Fit the convector to the 2 brackets “
D
”. Insert Brackets “
E
” to the
convector base and fix brackets “
E
” to the wall plugs by means of
the supplied screws.
Your convector is now wall mounted.
The appliances should not be installed directly under a wall power socket.
Do not use your heater in a bathroom.
The appliance should not be installed immediately below a
permanent mains outlet.
Position the appliance so that the plug and the outlet can be
easily reached even after installation.
Содержание HCO series
Страница 7: ...5713005900 09 06...
