21
18. DISPLAYED MESSAGES
DISPLAYED MESSAGE
POSSIBLE CAUSE
REMEDY
Fill tank
Insufficient water in the tank (A17).
Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place (fig. 3B).
Insert tank
The tank (A17) is not correctly in place.
Insert the tank correctly and press as far as it
will go (page 3B).
Empty grounds container
The grounds container (A11) is full.
Empty the grounds container and drip tray
(A15), clean and replace. Important: when
removing the drip tray, the grounds contain-
er MUST be emptied, even if it contains few
grounds. If this is not done, when you make
the next coffees, the grounds container may fill
up more than expected and clog the machine.
Insert grounds container
After cleaning, the grounds container (A11)
has not been replaced.
Remove the drip tray (A15) and insert the
grounds container.
Add pre-ground coffee
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel (A4).
Place pre-ground coffee in the funnel (fig. 11)
or deselect the "pre-ground" function.
A LONG coffee with pre-ground coffee has
been requested
Put one level measure of pre-ground coffee into
the pre-ground coffee funnel (A4) and press OK
(B3) to continue and complete preparation.
Fill beans container
The coffee beans have run out.
Fill the beans container (A3) (fig. 8).
The pre-ground coffee funnel (A4) is clogged. Empty the funnel with the help of the brush
(C5) as described in section “14.8 Cleaning the
pre-ground coffee funnel”.
Ground too fine
Adjust grinder
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
Repeat coffee delivery and turn the grinding
adjustment dial (A5) (fig. 7) one click clockwise
towards 7 while the coffee grinder is in opera-
tion. If after making at least 2 coffees delivery
is still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see section “9.1
Adjusting the coffee grinder”r”. If the problem
persists, make sure the water tank (A17) is fully
inserted.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Insert the hot water spout (C6) in the appli-
ance and deliver a little water until the flow
becomes regular.
Less coffee
Too much coffee has been used.
Select a lighter taste by pressing
(B7) or
reduce the quantity of pre-ground coffee.
Insert water spout
The hot water spout (C6) is not inserted or is
inserted incorrectly.
Fully insert the hot water spout (fig. 4).
→
