DeLonghi Dinamica Plus ECAM37 70 Series, Инструкция по эксплуатации

Страница: 23 / 28

23
PROBLEM POSSIBLE CAUSE REMEDY
The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
The infuser has cooled down because
2/3 minutes have elapsed since the last
coffee was made. Before making the coffee, heat the infuser by
rinsing using the rinse function (see section
"6.3 Rinse
" ).
A low coffee temperature is set. Set a higher coffee temperature in the menu
(section "6.9 Coffee temperature ").
Please note: Varying the temperature has
most effect for long beverages.
The coffee is weak or not creamy
enough. The coffee is ground too coarsely. Turn the grinding adjustment dial (A5) one
click anticlockwise towards "1" while the cof-
fee mill is in operation (fig. 13). Continue one
click at a time until the coffee is made satisfac-
torily. The effect is only visible after delivering
2 coffees (see section "7.5 Adjusting the coffee
mill").
The coffee is unsuitable. Use coffee for espresso machines.
The coffee is not fresh. The coffee pack has been opened for too long
and has lost its taste.
The coffee is delivered too slowly or a
drop at a time. The coffee is ground too finely. Turn the grinding adjustment dial (A5) one
click clockwise towards "7" while the coffee
mill is in operation (fig. 13). Continue one click
at a time until the coffee is made satisfactori-
ly. The effect is only visible after delivering 2
coffees (see section "7.5 Adjusting the coffee
mill").
Coffee does not come out of one or
both of the spouts. The coffee spouts (A9) are blocked. Clean the spouts with a toothpick (fig. 25B).
The appliance will not make coffee The appliance has detected impurities
in its internal circuits. "Cleaning under-
way" is displayed. Wait for the appliance to be ready again and
reselect the required beverage. Contact Cus-
tomer Services if the problem persists.
The appliance does not come on The power cord connector (D7) is not
inserted correctly. Insert the connector as far as it will go in the
socket at the back of the appliance (fig. 1).
It is not plugged into the mains socket. Plug into the mains socket (fig. 1).
The main switch (A22) is not turned on. Press the main switch (fig. 2).
18. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.