9
Contents
Installation
• Refer to Contents and Installation diagrams
•
Before installation of filter pump ensure pool is fully assembled and filled with water to the correct maximum level.
•
Low water level in the pool (and therefore the filter pump) will cause the filter pump motor to be noisy and could cause damage.
•
Remove filter pump from its packaging.
• Place the pump at least 0.2m below the level of the pool water and not more than 1m below the level of the pool water.
•
Mount the filter pump on solid and even ground (use the holes in the base of the pump to secure it to a solid surface, see Safety section.)
•
DO
NOT
place the pump in tall grass as it may cause the motor to overheat.
•
Make sure the filter pump is correctly assembled, as shown in the contents diagram.
•
Finger tighten the filter chamber cover retainer (P3), clockwise.
•
Connect filter hose (P12) to the inlet port of the filter pump (top) to the lower hose connection of the pool. Fix the hose with the clamps (P11).
• Gently turn the air purge cover (P1) anticlockwise 1-2 turns.
•
Connect the second filter hose (P12) to the upper hose connection of the pool and the outlet port (bottom) of the filter pump. Fix the
hose with the hose clamp, (P11).
Operation
• Ensure that all Safety and Installation instructions have been carried out.
•
With water flowing into the pump, water pressure will allow the air in the system to escape from the air purge cover (P1).
• Then gently tighten clockwise, the air purge cover (P1).
• Connect the mains supply after ensuring that all electrical and safety instructions have been carried out (refer to Electrical and General
safety sections above.)
•
Operate the filter pump until water becomes clear.
• Pump must
NOT
be used when the pool is occupied.
Maintenance
•
WARNING
! Disconnect from the mains supply before carrying out any maintenance procedures to the pool or the filter pump.
•
It is recommended to keep 2 spare filter cartridges at all times.
• CLEANING
•
Wash the outside of the filter with mild detergent and water
DO
NOT
use solvents.
• FILTER CLEANING/REPLACEMENT
•
Remove filter chamber cover retainer (P3), anticlockwise.
•
Clean the filter cartridge (P6), with running water, or replace if necessary.
•
Check the inside of the filter chamber, (P7). If dirt or sediment is found in the bottom of the chamber, flush the chamber out with a bucket
of water or use a hose.
•
Carefully refit the filter and the filter chamber cover and retainer ensuring all o rings are correctly positioned.
• Reconnect the mains supply.
• STORAGE
•
After the pool water has been completely emptied out remove all hoses from the pool and filter pump.
•
Empty water from all the housings of the filter pump.
• Store all components in a dry and ventilated location. Ensure all parts are dry.
Part no.
Description
Quantity
P1
Air purge cover
1
P2
Air purge cover seal
1
P3
Filter chamber cover retainer
1
P4
Filter chamber cover
1
P5
Filter chamber cover gasket
1
P6
Filter chamber
1
P7
Filter chamber
1
P8
Number not used
1
P9
Power cable
1
P10
O ring
2
P11
Hose clamp
4
P12
Connector hose
2
P13
Filter net
2
P14
Connector
2
