Installing The Thermal Fan
NOTE: To remove or locate the heat sink and fan assembly, see
Removing the Thermal Fan
.
1.
Place the fan into its slot on the computer.
2.
Replace and tighten the screw to secure the fan to the computer.
3.
Connect the thermal fan cable to the system board.
4.
Install the
system board
.
5.
Install the
coin cell battery
.
6.
Install the
card-reader board
.
7.
Install the
keyboard
.
8.
Install the
memory
.
9.
Install the
LED cover
.
10. Install the
wireless wide area network (WWAN) card
.
11. Install the
wireless local area network (WLAN) card
.
12. Install the
audio board and the hard drive
.
13. Install the
battery
.
14. Install the
base cover
.
15. Install the
Secure Digital (SD) card
.
16. Follow the procedures in
After Working Inside Your Computer
.
34
Содержание Vostro V130
