Troubleshooting |
61
To run the built-in diagnostics:
1.
Ensure that the screen is clean (no dust particles on the surface of the screen).
2.
Unplug the video cable(s) from the back of the computer or monitor. The monitor
then goes into the self-test mode.
3.
Press and hold
Button 3
and
Button 6
on the front panel simultaneously for 2
seconds. A gray screen appears.
4.
Carefully inspect the screen for abnormalities.
5.
Press
Button 6
on the front panel again. The color of the screen changes to red.
6.
Inspect the display for any abnormalities.
7.
Repeat steps 5 and 6 to inspect the display in green, blue, black, white and text
screens.
The test is complete when the text screen appears. To exit, press
Button 6
again.
If you do not detect any screen abnormalities upon using the built-in diagnostic tool, the
monitor is functioning properly. Check the video card and computer.
Common Problems
The following table contains general information about common monitor problems you
might encounter and the possible solutions:
Common
Symptoms
What You
Experience
Possible Solutions
No Video/Power
LED off
No picture
•
Ensure that the video cable connecting the monitor and the
computer is properly connected and secure.
•
Verify that the power outlet is functioning properly using
any other electrical equipment.
•
Ensure that the power button is depressed fully.
•
Ensure that the correct input source is selected via the
Input
Source
menu.
No Video/Power
LED on
No picture or no
brightness
•
Increase brightness & contrast controls via OSD.
•
Perform monitor self-test feature check.
•
Check for bent or broken pins in the video cable connector.
•
Run the built-in diagnostics.
•
Ensure that the correct input source is selected via the
Input
Source
menu.
Poor Focus
Picture is fuzzy,
blurry, or
ghosting
•
Perform
Auto Adjust
via OSD.
•
Adjust the
Phase
and
Pixel Clock
controls via OSD.
•
Eliminate video extension cables.
•
Reset the monitor to
Factory Settings
.
•
Change the video resolution to the correct aspect ratio.
