Dell PowerVault, Руководство пользователя

Страница: 38 / 396

• A disk group and associated RAID level
• The virtual disks
• Which hosts have access to the virtual disks
This section explains how to use the script commands to create a configuration from an array of
physical disks.
Determining What Is On Your Storage Array
Even when you create a configuration on a previously unconfigured storage array, you still need to
determine the hardware and software features that must be included with the storage array. When you
configure a storage array with an existing configuration, you must ensure that your new configuration
does not inadvertently alter the existing configuration, unless you are reconfiguring the entire storage
array. For example, to create a new disk group on unassigned physical disks, you must determine which
physical disks are available. The commands described in this section enable you to determine the
components and features in your storage array.
The
show storageArray
command returns the following general information about the components
and properties of the storage array:
• A detailed profile of the components and features in the storage array
• The battery age
• The default host type (which is the current host type)
• Other available host types
• The hot spare locations
• The identifiers for enabled features
• The logical and physical component profiles
• The time to which both RAID controller modules are set
• The RAID controller module that currently owns each virtual disk in the storage array
To return the most information about the storage array, run the
show storageArray
command with
the
profile
parameter. The following is an example of the complete CLI and script command running
on Windows:
client>smcli 123.45.67.89 -c "show storageArray profile;"
This example identifies the storage array by the dummy IP address 123.45.67.89. You can also identify the
storage array by name.
The
show storageArray profile
command returns detailed information about the storage array. The
information is presented in several screens on a display. You might need to increase the size of your
display buffer to see all of the information. Because this information is so detailed, you might want to
save the output to a file. To save the output to a file, enter the command as shown in the following
example:
client>smcli 123.45.67.89 -c "show storageArray profile;"
-o c:\ folder \ storageArrayprofile.txt
In this example, the name folder is the folder in which you choose to place the profile file, and
storageArrayprofile.txt is the name of the file. You can choose any folder and any file name.
CAUTION: When you write information to a file, the script engine does not check to determine if
the file name already exists. If you choose the name of a file that already exists, the script engine
writes over the information in the file without warning.
38