Dell PowerEdge M1000e, Руководство пользователя

Страница: 273 / 346

Installing Enclosure Components
273
3 Reinstall the CMC module and reattach any cables that were
disconnected. See "Installing a CMC Module" on page 273.
On a single CMC system, the SD card activates automatically. For redundant
CMC module systems, initiate a changeover to make the passive module
active using the following steps:
1 Navigate to the Chassis page.
2
Click the Power Management tab.
3
Click the Control sub tab.
4
Select the
Reset CMC
(warm boot) button.
5
Click
Apply
.
The CMC will automatically fail over to the redundant module, and that
module now becomes active and displays a solid blue status LED. The SD
card activates automatically.
See the CMC User’s Guide for information on configuration and usage of the
FlexAddress feature.
Installing a CMC Module
1 Remove the I/O connector cover. See Figure 4-4.
2 Ensure that the CMC module handle is fully open.
3
Slide the module into the enclosure until the handle contacts the
enclosure.
4
To fully seat the module, close the handle until the release latch snaps into
place.
5
Reconnect the cables that were attached to the module.