4. Disassembly and Assembly Procedures
4
.2 Assembly Procedures:
Turn over the bracket chassis module.
Use a Philips-head screwdriver to tighten two screws
for locking the AC power outlet.
Use a Hex-
head screwdriver to tighten two Hex Nuts for locking
the D-Sub connector.
(No.1~2 screw size=M3x8, Torque=6
±0.5
kgfxcm)
(No.3~4 screw size=M3x8, Torque=6~7kgfxcm;
S6
S5
Panel preparation: Examine the panel surface
according to inspection criteria. Turn over the panel
to place the screen faced down, then Use a Jp to
stick a piece of mylar on the specific position as the
picture below shown.
(Note: you must stick a piece of
mylar when you change a new panel.)
S7
mylar
2
1
4
3
Turn over a power board and put the power board
into the bracket chassis, locate the panel power
cable into the hook of the bracket chassis.
Place a bracket chassis base on a protective
cushion.
S2
S1
Take a interface board, connect a LVDS cable to the
connector of the interface board, then connect the
cable of the power board to CN2202 of the interface
board. Turn over the interface board and locate it into
the bracket. Use a Philips-head screwdriver to tighten
six screws for locking the power board and interface
board.
(No.1 screw size=M4x8, Torque=6
±0.5
kgfxcm;
No.2~6 screw size=M3x7.5, Torque=6
±0.5
kgfxcm)
3
Cn2202
2
S3
1
6
5
Put the bracket chassis module on the back of LCD
module.
4
