Back to Contents Page
Smart Card Reader
Dell™ Latitude™ D410 Service Manual
Removing the Smart Card Reader
Replacing the Smart Card Reader
Removing the Smart Card Reader
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Remove the
center control cover
.
3.
Remove the
keyboard
.
4.
Remove the
display assembly
.
5.
Remove the
palm rest
.
6.
Remove the M2 x 3-mm screw from the smart card reader.
7.
Disconnect the smart card cable from the system board.
a.
Use a plastic scribe or small flat-head screwdriver to lift the top part of the system board connector for the smart card reader.
b.
Lift the smart card cable out of the connector.
8.
Slide the smart card reader back, and then lift up the card to remove it from the hard drive cage.
Replacing the Smart Card Reader
1.
Slide the smart card reader back into the hard drive cage.
2.
Reconnect the smart-card reader cable to the system board.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide
.
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface.
1 smart-card reader
connector
2 smart-card reader cable
3 M2 x 3-mm screw
4 smart card reader
Содержание Latitude D410
