Dell Latitude 3410, Руководство по обслуживанию

Страница: 60 / 104

4. Disconnect the battery .
5. Remove the WLAN card .
NOTE: Hall Sensor is a part of the IO board and the entire IO board needs to be replaced if the Hall Sensor is faulty.
About this task
The following images indicate the location of the memory module and provide a visual representation of the removal procedure.
Steps
1. Remove the two (M2.5x5) screws from the left hinge and lift the hinge up.
2. Peel back the adhesive tape covering the IO board connector cable and disconnect it from the system board.
3. Disconnect the cable connectors from the IO board in the following order (left - right): USB data cable, Coin-cell battery
cable, Audio FFC cable.
4. Remove the single (M2x5) screw that is holding the IO board in place and lift the module away from the computer.
Installing the IO Board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the IO board and provides a visual representation of the installation procedure.
60 Disassembly and reassembly