7.
Align the notches on the bottom of the module with the crossbars in the connector.
8.
Insert the module straight down into the connector, ensuring that it fits into the vertical guides at each end of the connector. Press firmly on the ends
of the module until it snaps into place.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
9.
Close the computer cover
.
10.
Connect your computer and devices to their electrical outlets, and turn them on.
11.
Right-click the
My Computer
icon and then click
Properties
.
12.
Click the
General
tab.
13.
To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Replacing an AGP Card
1.
Shut down the computer
.
2.
Turn off any attached devices and disconnect them from their electrical outlets.
3.
Disconnect the power cable from your computer, and then press the power button to ground the system board.
4.
Open the computer cover
.
5.
Press the card clip lever on the side of the AGP card to release the card from the slot connector, and remove the card.
NOTICE:
To avoid breaking the memory module, do not press near the middle of the module.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in "
Safety Instructions
."
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
Содержание Inspiron 8200
Страница 45: ...Back to Contents Page ...
