Dell Inspiron 24 3000 series, Руководство по обслуживанию

Страница: 54 / 79

Replacing the system board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer . After working inside your
computer, follow the instructions in After working inside your
computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
NOTE: Your computer’s Service Tag is stored in the system board. You
must enter the Service Tag in the BIOS setup program after you replace
the system board.
NOTE: Replacing the system board removes any changes you have
made to the BIOS using the BIOS setup program. You must make the
desired changes again after you replace the system board.
Procedure
1 Slide the ports on the system board into the slots on the display-
assembly base and place the system board on the display-assembly base.
2 Align the screw holes on the system board with the screw holes on the
display-assembly base.
3 Replace the screws that secure the system board to the display-assembly
base.
4 Connect the display-backlight cable to its connector on the system
board.
5 Slide the control-buttons board and display cables into its connectors on
the system board and press down on the latches to secure the cables.
6 Connect the speaker, touch-control board, hard-drive, optical-drive,
hard-drive and optical-drive power, fan, and microphone and camera
cables to its connectors on the system board.
54