About this task
NOTE:
If either the system board or the heat sink is replaced, use the thermal grease provided in the kit to ensure that
thermal conductivity is achieved.
The following image(s) indicate the location of the speakers and provides a visual representation of the installation procedure.
Steps
1. Using the alignment posts, place the left and right speakers on the palm-rest and keyboard assembly.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the speaker cable to the palm-rest and keyboard assembly.
4. Connect the touchpad cable and close the latch of the touchpad connector on the system board.
5. Connect the keyboard cable and close the latch of the keyboard connector on the system board.
6. Connect the keyboard backlit cable and close the latch of the keyboard backlit connector on the system board.
Removing and installing components
45