Removing the rear VGA port
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3.
Steps
1. Disconnect the VGA port cable from the video connector on the rear I/O board and open the latch on the expansion card
riser.
2. Slide the VGA port out of the expansion card riser.
Figure 116. Removing the VGA port
3. If the VGA module is not going to be replaced, install a filler bracket and close the card retention latch.
Figure 117. Installing the filler bracket
Installing and removing system components
131
