3
Remove the following:
a
Air shroud
b
All expansion cards and risers
c
Internal PERC riser
d
vFlash/IDSDM module
e
Internal USB key (if installed)
f
USB 3.0 module (if installed)
g
Processors and heat sink modules
h
Processors blanks (if applicable)
CAUTION:
To prevent damage to the processor socket when replacing a faulty system board, ensure that
you cover the processor socket with the processor dust cover.
i
Memory modules and memory module blanks
j
LOM riser card
k
Drive cage (rear) (if applicable)
Steps
1
Disconnect all cables from the system board.
CAUTION:
Take care not to damage the system identification button while removing the system board from the chassis.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
2
Using Phillips #2 screwdriver, remove nine screws securing the system board to the chassis.
Figure 118. System board screws
3
Hold the system board holder, slightly lift the system board, and then slide it toward the front of the chassis.
164
Installing and removing system components