CAUTION:
Take care not to damage the system identification button while placing the system board into the chassis.
2
Holding the system board holder, push the system board toward the back of the system till it is seated.
3
Using Phillips #2 screwdriver, tighten the screws to secure the system board to the chassis.
Figure 120. Installing system board
Next steps
1
Install the Trusted Platform Module (TPM).
NOTE:
The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module is provided for all system board replacements, where a TPM plug-in module was installed.
2
Replace the following:
a
Internal PERC riser
b
Internal USB key (if applicable)
c
USB 3.0 module (if applicable)
d
IDSDM/vFlash module card
e
All expansion cards and risers
f
Processors and heat sink modules
g
Processors blanks (if applicable)
h
Memory modules and memory module blanks
i
LOM riser card
j
Air shroud
k
Drive cage (rear) (if applicable)
3
Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4
Follow the procedure listed in
After working inside your system
.
166
Installing and removing system components
